The sooner drying starts, the less there is to repair. Our phones are answered around the clock, with same-day visits when available.
You focus on your home. We put together the photos, readings and reports your insurance company needs.
Every technician is IICRC certified and has handled bathroom water damage many times. You get a clear plan before any work starts.
Most people who call us have never dealt with bathroom water damage before. We walk you through it on the phone, then send a local crew with the right equipment.
Tile, tubs and fixtures are made to get wet on top, but what lies beneath them is not. Once caulk splits, grout thins out or the toilet seal gives up, each shower and flush sends a bit of water through. That water gathers where you cannot see it, in the subfloor and inside the tiled wall. In Staten Island, we locate the entry point, measure how far the water has spread, then dry or take out the wet material.
Because the leak is usually slow, the damage tends to be older and deeper than it looks. Subfloor under a toilet can be soft all the way through while the tile above still looks fine. With thermal imaging and moisture meters, we map what is wet before any demolition, and we open just the sections that will not dry in place.
With a crack in the liner or pan, water escapes below the shower floor at each use. Framing under the shower stays saturated even though the surface shows no flaw.
A failed wax ring leaks a little with every flush. The water is category 3, and it rots the subfloor around the flange until the toilet starts to rock.
A weak or missing exhaust fan leaves steam in the room after every shower. Mold feeds on the moisture that lands on ceilings and walls, and damp materials dry far more slowly.
Neither grout nor tile is a waterproof barrier without help. Mold takes hold on the wall board once that hidden layer remains wet, and no scrubbing can get to it.
A little water passes the failed grout or caulk every time someone showers. It soaks into the backer board and the edge of the subfloor, with nothing visible yet.
Between showers, the wood below the tile has no time to dry out. Mold gets going in the wall cavity and on the floor's underside.
You see darker grout, loosening tiles and blackened caulk. A stain shows on the ceiling of any room below and slowly grows.
Joists can begin to rot, and the subfloor near the toilet or tub becomes soft. At this point the job means new tile and carpentry on top of the drying.
We save what can be dried properly and remove only what cannot. Moisture readings make that call, not guesswork.
Call (239) 268-6506| Material | Can usually be saved when | Has to be replaced when |
|---|---|---|
| Tile backer board | Cement board that is wet but intact and free of mold | Behind the tile, green board or drywall that has gone soft |
| Sheet vinyl flooring | Edges and seams are still sealed, so nothing got underneath | Moisture is trapped under it, or it has curled, lifted or discolored |
| Ceramic tile | The bond is intact and the subfloor underneath is dryable | The tiles have come loose, or the floor below feels soft |
| Vanity cabinet | Solid wood or plywood with only brief contact with water | Swollen, split or moldy particleboard |
| Ceiling below | Just a small stain, and the drywall is firm and flat | Soaked through from above, or starting to sag or crumble |
We test the tub, shower, toilet and supply lines one at a time, and use moisture meters and thermal imaging to see where water has traveled under tile and inside walls.
Soft wall board, loose tile and subfloor that has rotted are removed. If the toilet was the source, we handle that section as contaminated, and porous materials we cannot clean go.
Using dehumidifiers and air movers, we dry the wall framing, the subfloor and the ceiling cavity underneath. We apply antimicrobial treatment and confirm dry readings before anything is closed up.
New subfloor and backer board go in, and we can coordinate the tile, toilet seal, caulk and ceiling work, meaning the path of the leak gets closed and not just hidden.
Have a different question? Call us and we will answer it over the phone.
Call (239) 268-6506Take action now and prevent costly damage. Staten Island Restoration is ready to help.
Call (239) 268-6506 Now